It is no longer the preferred interface, and will eventually be removed from Mach3. Plugin Supported Interface The legacy interface was the initial Modbus interface initially targeting the ModIO™ device. I tried toggling the 'jog on/off ctrl-alt-j' but that didn't do it.Īdditionally, for Modbus over a serial line, Mach3 has two methods. ![]() Is there a button that could enable/disable the gamepad jogging? I'd hate to bump one of the sticks and crash my tool. But I do have two questions that would save me a bit of time hunting if anybody here could be so kind. Alright, I got the logitech dual action controller, fired up key grabber, and everything is working PERFECTLY so far. Has anybody used just a cheap USB gamepad and a key mapping software to map (for example) the left button on the gamepad to the left arrow on the keyboard, etc., etc.? Then somehow mapped any of the buttons on the gamepad to the.001.01 &.1 increments? I was hoping to get a little encouragement before I wasted a few hours and $25. ![]() ![]() ![]() I've read several threads where people have done similar things, but I'm looking for quick and easy. Hello, I am going to attempt to use a cheap USB gamepad as a hand pendant.
0 Comments
Leave a Reply. |